Savin 2045e - Manual (Page 19)

Preparing the Machine
13
2
C
Gently insert paper face down
into the bypass tray until the
beeper sounds.
1. Extender
2. Paper guides
Note
ˆ The beeper will not sound if it is
turned off. Gently insert paper
until it stops.
ˆ Do not stack paper over the lim-
it mark, otherwise a skewed im-
age or misfeeds might occur.
ˆ Open out the extender to sup-
port paper sizes larger than A4
L, 8
1 /
2
"
×
11" L.
ˆ Fan the paper to get air between
the sheets to avoid a multi-sheet
feed.
ˆ When setting an OHP transpar-
ency, make sure that its front
and back sides are properly po-
sitioned.
ˆ Select paper type when printing
onto OHP transparencies or
thick paper (over 105g/m
2 ). For
details, see p.14 “Setting thick
paper or OHP transparencies”.
D
Select the paper size.
Note
ˆ You can set paper size using the
printer driver. The following
procedures are not necessary
when setting paper size using
the printer driver.
ˆ The paper size set using the
printer driver has priority over
that set using the display panel.
ˆ When the printer driver is not
used, make settings using the
display panel.
Reference
For printer driver settings, see
the printer driver Help.
For details about setting custom
sizes, see p.14 “Setting custom
size paper”.
A Press the {User Tools/Counter}
key on the control panel.
B Press [ Printer Features ] .
C Press the [ Paper Input ] tab.
D Press [ Bypass Paper Size ] .
E Select the paper size.
Note
ˆ Press [ UPrev. ] or [ TNext. ] to
scroll through the list.
ˆ When printing onto thick pa-
per or OHP transparencies,
select paper type. For details,
see p.14 “Setting thick paper
or OHP transparencies”.
F Press [ OK ] .
G Press the {User Tools/Counter}
key.
ZEFH061E
ZCAS100N