Sharp XG - NV6XU - Manual (Page 16)

E-15
Setup & Connections
Connecting the Remote Mouse Receiver
• You can use the remote control as a remote mouse.
• When the RS-232C port on the projector is connected to a computer with
an RS-232C cable (cross type, sold separately), the computer can be
used to control the projector and check the status of the projector. See
pages 52 and 53 for details.
2. Connecting the Projector Continued
IBM or IBM compatible PC
Remote mouse
receiver
RUNTK0661CEZZ Mouse control
serial cable
QCNW-5112CEZZ Mouse control cable
for IBM PS/2
QCNW-5113CEZZ
or
Mouse control
serial cable
QCNW-5112CEZZ Mouse control cable
for Mac
QCNW-5114CEZZ Remote mouse
receiver
RUNTK0661CEZZ
Remote mouse receiver
Use this terminal to con-
nect the supplied
mouse control cable to
the remote mouse
receiver.
IBM PC/AT IBM PS/2
1 Connect one end of the supplied mouse control cable to the corresponding terminal on the PC.
2 Connect the other end to the remote mouse receiver.
Macintosh
1 Connect the mouse control serial cable to the remote mouse receiver.
2 Connect the mouse control cable for Mac to the Mac ADB port on the Mac.
3 Connect the other end of the mouse control cable for Mac to the mouse control serial cable.
CAUTION
• Do not connect or remove the mouse control cables to or from the computer while it
is on. This may damage your computer.
• The wireless mouse functions can operate computers compatible with IBM PS/2, serial
(RS-232C) or Apple ADB type mouse systems.