Socket Mobile Pentium 4 Full Size PICMG CPU Card IB810 - Manual (Page 11)

INSTALLATIONS
IB810 User’s Manual 7
ATX Power Installation
Power is provided to the IB810 CPU card with the J2 and J12 ATX power
connectors. Please note that the J12 external ATX power connector
should be connected to the backplane for IB810 to function. J12 is
located below the IDE connector. Please refer to the figure below.
MicroPCI Daughter Card Installation
The IB810 CPU card is integrated with a MicroPCI socket that uses
SO-DIMM 144-pin connectors. These sockets can accommodate the
optional MicroPCI daughter cards.
To insert the MicroPCI daughter cards, position it at 30
°
to the PCB and
gently push it into the MicroPCI connector (See Figure 1 below). The
card will not fit when inserted at an angle of 45
°
or 15
°
. Once inserted,
slowly press the card towards the PCB until it locks on both sides to the
clips of the connector. Screw the card to the PCB to secure the
installation. To remove the MicroPCI card, pull the ‘clips’ sideways as
shown in Figure 2 below.
Figure 1. Figure 2.