Star Trac Spinning Bike Computer - Manual (Page 15)

12
Time required:
•
15 Minutes
Parts required:
•
727-0083 Spinning ® Computer Kit
NOTE: The thin spacer is used on Pro 5800/6800 and Elite 5900 bikes.
Tools required:
•
M5 Allen Wrench
•
M2 Allen Wrench
1.
Place the thin insert inside the bottom part of the Mounting Bracket Clamp.
Then position the mounting bracket onto the center-curved portion of the handlebars. Once positioned correctly,
tighten the 4 M6x20 screws using the M5 Allen tool.
2.
Install the computer onto the mounting bracket by sliding the computer clamp over the long portion of the bracket.
Tighten computer clamp with the M6 screw and nut using the M5 Allen
tool.
Installation Procedure Pro 5800 / 6800 / Elite 5900