Replacing a print unit, Replacing a print unit 139, Replacing consumables 139 replacing a print unit – Konica Minolta BIZHUB C30P User Manual
Page 153
Replacing Consumables
139
Replacing a Print Unit
When replacing a print unit, refer to the following table. For optimum print
quality and performance, use only approved KONICA MINOLTA print units for
your specific printer type, as listed in the table below. You can find your printer
type and the print unit part numbers on the consumables reorder label inside
the front cover your printer.
"
“
I-UNIT
” displayed in the control panel refers to the print unit.
Note
Do not touch the OPC drum
surface. This could lower image
quality.
If
I-UNIT LOW
on the
SYS DEFAULT MENU/ENABLE WARNING
is set
to
ON
, the message
I-UNIT LOW X
(where “
X
”. represents the color of the
toner) appears when a print unit becomes empty. Follow the steps below to
replace the print unit.
"
You are advised to replace the indicated print unit when the message
I-UNIT LIFE X
appears.
1
Check the message window to see which color print unit needs replacing.
Printer
Type
Printer Parts
Number
Print Unit Type
Print Unit Parts
Number
EU
A011 024
Print Unit - Black (K)
A031 00J
Print Unit - Yellow (Y)
A031 05J
Print Unit - Magenta (M)
A031 0AJ
Print Unit - Cyan (C)
A031 0GJ
Y
PU
SH