KORG TRINITY HDR-TRI - Manual (Page 14)

Recording
11
Introduction
Operation
Parameters
Appendix
Recording a guitar in stereo on tracks 3 and 4
while listening to audio tracks 1 and 2
1 Use the procedure of “Recording an audio track” to record onto audio tracks 1
and 2.
2 Connect your guitar to a stereo-output effect device.
3 Connect the stereo-output effect device to the ANALOG IN 1 and 2 jacks.
Checking the external input
4 In the Track setting, select AT3&4.
The input to the ANALOG IN 1 jack will be recorded onto audio track 3, and the
input to the ANALOG IN 2 jack will be recorded onto audio track 4.
5 In the Input Select setting, select Analog.
6 In the Input Level setting, select –30 dBu.
7 Play your guitar, and adjust the Rec Level so that the level meter does not rise all
the way.
If the Input Level indicates Overload, the input level is too great. If this occurs,
select the next higher setting for Input Level.
8 Press the [RESET] key to return to the beginning of the song. Press the [REC/WRITE]
key and then (after making sure that the [START/STOP] key LED is blinking) press
the [START/STOP] key.
Recording will begin. While listening to audio tracks 1 and 2, play your guitar
and record it on audio tracks 3 and 4.
9 To stop recording, press the [START/STOP] key.
The Compare function
If you press the [COMPARE] key, the TRINITY will return to the state it was in
before recording began (this is referred to as the Compare function). Press the
[COMPARE] key once again, and the recorded data will reappear.
7
4
5
6