KORG TRINITY HDR-TRI - Manual (Page 8)

Settings for recording
5
Introduction
Operation
Parameters
Appendix
If you are using only a single hard disk to perform hard disk recording,
you must specify a filer partition larger than
0 in order to create an area
where .SNG files and .PCG files etc. can be saved. If you are using two or
more hard disks, a filer partition must be created on at least one of the
disks.
5 Press the OK button to execute formatting.
Formatting a hard disk will require a certain amount of time depending on the
size of the hard disk. (e.g., formatting a 540 Mbyte hard disk requires approxi-
mately 5 minutes.)
After formatting has been executed, pressing the [COMPARE] key will not
restore the original state of the disk.
Do not install a hard disk that was formatted on the TRINITY series into
another computer. Korg cannot guarantee the operation of such a disk.
Types of SCSI devices that can be connected and
their ID settings
SCSI devices other than hard disks can also be connected, including removable
media such as magneto-optical disks (MO).
Hard disks can be set freely to any ID number 0–6, but a removable media
device can be used only when its ID number is set to 6.
If you have connected only one removable media device, and no other device is
connected, that removable media can be used to load and save .SNG files.
However if one or more hard disks are also connected in addition to the remov-
able media device, the hard disk(s) will be able to record sound and load/save
.SNG files, but the removable media device will not be able to record sounds nor
load/save .SNG files. The removable media device will be usable only for oper-
ations such as “Copy with Sound” (
☞ page 52 of this manual) or “Copy”
( ☞ page 47 of this manual).