Kawasaki 76920 - Manual (Page 10)

13
10
12
14
Assembly
Steering
Column
Cap Nut
Handlebar
Hole
Handlebar Wire
Harness
Steering Column Bushing
• Position the vehicle body upright.
• While fitting the handlebar onto the end of the steering
column, insert the end of the handlebar wire harness
through the hole in the front of the vehicle body.
• Fit a cap nut onto the end of the steering column.
Helpful Hint: You may need the help of another adult to
support the curved end of the steering column near the
steering linkage to fit and secure the cap nut on the
straight end of the steering column.
• Tap the cap nut with a hammer to secure it on the end of
the steering column.
End of Steering
Column
Cap Nut
• Turn the vehicle body on its side.
• Fit a cap nut on the end of the steering column.
• Tap the cap nut with a hammer to secure it on the end of
the steering column.
Main Wire
Harness
Connector
Opening
Handlebar Wire
Harness Connector
• Insert the wire connector on the main wire harness
through the large opening in the center of the
vehicle body.
• Plug the main wire harness connector and the handlebar
wire harness connector together.
11
Steering
Column
Steering
Linkage
Hole
Guides
• Turn the vehicle body on its side.
• Insert the curved end of the steering column into the hole
in the steering linkage. Make sure the steering column
is positioned between the guides on the underside of
the vehicle body.