Kawasaki 76920 - Manual (Page 7)

IMPO RTA NT
A 25 AMP FUS E MU ST
BE IN STALL ED IN TOP
OF B ATTE RY B EFO RE
TOY WIL L RE CHA RGE
OR O PER ATE
• Plug the charger into a standard wall outlet.
Note: If power flow to the wall outlet is controlled by a
switch, make sure the switch is “ON”.
• Before first-time use, charge the battery for at least 18
hours. Never charge the battery longer than 30 hours.
Note: The battery must be upright while charging.
• Recharge the battery for at least 18 hours after each use
of your vehicle. Do not charge the battery longer than
30 hours.
• Once the battery is charged, disconnect the charger
connector from the battery connector. Unplug the
charger from the wall outlet. The battery is now ready to
be installed in your vehicle. Please see the Battery
Installation section on page 14 for detailed instructions
on installing your battery. If your battery is already
installed in your vehicle, simply re-connect the battery
connector and motor harness connector, re-assemble
the seat and lock the lock fastener.
• If you are charging the battery for the first time, insert a
25 amp fuse into the battery.
Note: The top of the fuse will not be flush with the top of
the battery when properly installed.
• If you are recharging your battery, make sure the 25 amp
fuse already installed in the battery is in good condition.
Remove the fuse from the battery and look at it to make
sure it is not blown. Replace a blown fuse with a new
Power Wheels
® 25 amp fuse.
25 Amp Fuse
1 3
Battery
Connector Charger
Connector
2
• Plug the charger and battery connectors together.
IMPORTANT NOTE! If you are recharging your battery,
you will first need to disconnect the battery connector from
the motor harness connector under the seat.
7
GOOD FUSE "BLOWN" FUSE
Battery Charging
Charger