Kawasaki 76920 - Manual (Page 8)

Do not omit any steps. Please set aside at least
30 minutes for assembly.
8
3
2
Inset
1
5
Assembly
F
13
• Apply label #13 to the recessed circle on each front
wheel, as shown.
Wheel Bushing
• Turn the front wheels over.
• Fit a wheel bushing into the rectangular opening in each
front wheel.
Fork
Axle/Linkage
Assembly
Center Axle
Vehicle Body
Front Wheel
Front Axle
Washer
Wheel Bushing
Vehicle Body
Please Note: If the axle/linkage assembly has detached
from the vehicle body during shipment, please fit it back
onto the fork on the front of the vehicle body. Make sure
the center axle is toward the rear of the vehicle.
• Turn the vehicle body upside down.
Cap Nut
Round Bushing
4
• Slide a round bushing onto the front axle and press it into
the center of the front wheel.
• Fit a cap nut onto the end of the front axle.
• Tap the cap nut with a hammer to secure it on the
front axle.
• Repeat assembly steps 3 and 4 to assemble the other
front wheel to the other side of the front axle.
• Position the vehicle body upright.
Handlebar
Button End
Handlebar
Wire
Harness
Rectangular Opening
Connector End
• Insert the connector end of the handlebar wire harness
into the rectangular opening in the handlebar.
• Feed the handlebar wire harness through the handlebar.
• Push firmly on the button end of the handlebar wire
harness to snap it into the rectangular opening.
• Fit a washer onto one end of the front axle.
• Slide a front wheel, bushing side first, onto the front axle.