Kodak NOVAJET 750 User Manual
Page 17
NJ750 Training Guide
17
4.
Faint cut lines or heavy lines which angle slightly on one end are caused
by the carriage head hitting the media surface. Media up to a 20 mil
thickness can pass through the printer. Ensure media has not been
exposed to humidity for long periods as this will cause media to become
stiff. Check with technical support for media types which can pass
through the printer.
5.
Printer carriage hesitation. Hesitation of the carriage assembly during
printing can be due to various factors; i.e. Slow processor in workstation
for Software RIPs, screen saver turned on, improperly configured parallel
port for non-networked environments, incorrect speed setting for driver
data transfer rate, print server setup (untested print server used/incorrect
SEH setup), other network traffic, etc.
6.
Horizontal bands which extend the width of the image and repeat at a
relatively consistent rate are usually caused by the Autowipe feature being
turned on or improper ink pre-heat settings.