Key Digital KD-DA6 - Manual (Page 12)

compatible with the “Display” device. Make sure
that the “Source” signal is of a valid format that can
be displayed by the connected “Display” device; for
example: if the “Display” device connected is not
capable of handling HDTV compatible video signals
make sure that the “Source” device is set to output
SD (Standard definition or 480i) compatible signals.
I have a picture but there is noise or “hum bars”
visible in the image.
This could happen when crossing power lines when
routing the cable from the “Source” device to the KD-
DA6 or KD-CDA12, or when routing the cables from
the KD-DA6 or KD-CDA12 to the “Display” device. If
crossing power lines is inevitable, make sure to use
heavy shielded good quality cable like Key Digital
techFlex heavy gauge AV cable (refer to main catalog
for cable selections, or Key Digital’s interactive web-
site:
www.keydigital.com
Sometimes using a shielded and noise filtering surge
oritector can eliminate noise in power lines.
I have No Audio.
When connecting the Left and Right (White and Red
connector) stereo audio channel make sure that the
connectors are properly connected to the “Source”
device as well as the “Display” device.
Make sure that the volume is turned up to an audible
level on the “Source” device as well as the “Display”
device.
Page 12
HD View 6
OP E R AT ING IN S T R U C T ION S
Model KD-DA6