King Canada 9818-RJ - Manual (Page 13)

IMPORTANT!
Coax connection will slide
inside rubber sleeve.
Coax connections
should be snug.
DO NOT OVER TIGHTEN!
Gel-filled boots must sit
flush against
rubber sleeve.
Fig. 9
4. Run coax cable(s) from the dome unit to the location where they will enter the vessel.
Secure coax every 12-18 inches.
5. Drill 3/4” hole in the vessel where the tuner will be located. Feed coax cables(s) down
through hole. Seal opening so that it is entirely waterproof (inside and outside of the
3/4” hole).
6. Replace dome cover on base and align holes in dome cover with holes in base. Attach
dome cover with dome cover screws saved earlier. Tighten ALL screws securely.
2. Connect 50’ coax cable to the coax port labeled MAIN on the bottom of the dome unit and
tighten connection. If using a second receiver, connect second 50’ coax cable to the
unlabeled port and tighten connection. DO NOT OVER TIGHTEN CONNECTIONS
(Fig. 9).
3. Snap the gel-filled boots around the coax cables, then push flush against the rubber
sleeves on the coax ports (Fig. 9).
IMPORTANT! When re-installing the dome cover, CAREFULLY lower it onto the base,
tilting it side to side as necessary to prevent damaging internal
components.
Page 11