King Canada 9818-RJ - Manual (Page 18)

The Faceplate is optional and can be removed as follows: (Fig. 13)
1. Remove 4 screws from Controller.
2. Slide Faceplate off of Controller.
3. Replace 4 screws.
Page 16
OPTIONAL WALL MOUNT FACEPLATE (INCLUDED)
1. Use the Faceplate as a template to mark and cut out the mounting cavity, and if
necessary, mark and drill the mounting holes (Fig. 12).
2. Mount Faceplate in wall with supplied screws.
Fig. 13
Note:
Depending on the
mounting surface, pilot
holes for the screws
may or may not need to
be drilled.
Fig. 12
Note: If not using the faceplate, see faceplate removal instructions below.
IMPORTANT! Depending on the thickness of the vessel wall, a relief notch may need to
be cut for the cable. THE CABLE MUST NOT BE PINCHED OR BENT
WHEN MOUNTING THE DISPLAY.