Installation and connection, Required tools and equipment, Unpacking and preparation – Kathrein MobiSet 3 Digital CAP 700 User Manual
Page 9: Selecting the installation location
9
•
Circular cutter, Ø 38 mm
•
Flat-bladed screwdriver for M5 screws
• Power
drill
•
Galvanised round head screws, depending on the roof structure (Ø: 5 mm, sheet metal screws D 7981,
depending on the roof structure) or round head screws D 7985 with washers and nuts
•
Twist drill, Ø 2.5 or 5.5 mm
• Round
fi le and/or emery paper
• Cleaning
agent
•
Open-ended or ring spanners 10 and 11 mm across fl ats
• Knife
•
Cross-head screwdrivers for M3 and M5 screws
•
Torque wrench capacity 6 to 11 Nm
•
Hexagon socket key (5 mm)
•
Two wooden beams for supporting the turntable
REQUIRED TOOLS AND EQUIPMENT
INSTALLATION AND CONNECTION
The CAP 700 must not be mounted on the satellite
dish, since this could cause it to distort. Keep the
CAP 700 in its cardboard box for transport on to the
vehicle roof.
Retain the original packaging, as if it is necessary
to send the unit for repair transport damage
cannot be ruled out and the manufacturer accepts
no liability for possible damage.
Loosen the six fastening screws (width A/F:
10 mm). Carefully lift the turntable off the mounting
plate and place it on the prepared wooden
supports. Make sure that the cables are not
crushed where they emerge from the underside of
the turntable.
UNPACKING AND PREPARATION
Essentially, the cable lengths of the MobiSet 3 CAP 700 components allow you a free choice of installation
location on your caravan or motor home.
However, you should take note of the following points:
•
Before installation, you should fi nd out whether the operating manual for your vehicle permits the
fi tting of non-vehicle-specifi c parts or what requirements need to be met in order to do so.
•
For direct satellite reception, there should be no obstructions between the antenna and the satellite.
Therefore, make sure that the antenna is not shadowed by roof extensions such as luggage racks,
air conditioning units, solar panels, etc. The problem of shadowing applies also to the selection of the
parking place for your vehicle. For interference-free satellite reception, the antenna needs a projected
free view to the South at an angle of between 0° and 75° (depending on location) to the horizontal.
SELECTING THE INSTALLATION LOCATION
The CAP 700 packaging can be opened along
both long sides. This allows easier access to the
fastening screws.