Before applying power, Safety precautions, Warning – Kenwood XD-9581MD User Manual

Page 2: Requirement by nederland gazette

Advertising
background image

XD-9581MD (En)

2

Preparation section

Basic section

Application section

Knowledge sections

Before applying power

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER
(OR BACK). NO USER-SERVICEABLE PARTS INSIDE, REFER SERVICING TO QUALI-
FIED SERVICE PERSONNEL.

RISK OF ELECTRIC SHOCK

DO NOT OPEN

THE LIGHTNING FLASH WITH ARROWHEAD SYMBOL, WITHIN AN EQUILATERAL TRIANGLE, IS IN-
TENDED TO ALERT THE USER TO THE PRESENCE OF UNINSULATED “DANGEROUS VOLTAGE”
WITHIN THE PRODUCT’S ENCLOSURE THAT MAY BE OF SUFFICIENT MAGNITUDE TO CONSTITUTE
A RISK OF ELECTRIC SHOCK TO PERSONS.

THE EXCLAMATION POINT WITHIN AN EQUILATERAL TRIANGLE IS INTENDED TO ALERT THE USER
TO THE PRESENCE OF IMPORTANT OPERATING AND MAINTENANCE (SERVICING) INSTRUCTIONS
IN THE LITERATURE ACCOMPANYING THE APPLIANCE.

Units are designed for operation as follows.

Europe and U.K. ........................................................................ AC 230 V only

Safety precautions

WARNING

: TO PREVENT FIRE OR ELECTRIC SHOCK,

DO NOT EXPOSE THIS APPLIANCE TO
RAIN OR MOISTURE.

CAUTION

The marking is located on the rear panel and says that the com-
ponent uses laser beams that have been classified as Class 1. It
means that the unit is utilizing laser beams that are of a weaker
class. There is no danger of hazardous radiation outside the unit.

CLASS 1

LASER PRODUCT

The marking of products using lasers

(Except for some areas)

Before applying power

Caution : Read this page carefully to ensure safe operation.

Factory fitted moulded mains plug

1. The mains plug contains a fuse. For replacement, use only a 13-Amp

ASTA-approved (BS 1362) fuse.

2. The fuse cover must be refitted when replacing the fuse in the

moulded plug.

3. Do not cut off the mains plug from this equipment. If the plug fitted

is not suitable for the power points in your home or the cable is too
short to reach.
A power point, then obtain an appropriate safety approved extension
lead or adapter, or consult your dealer.
If nonetheless the mains plug is cut off, remove the fuse and
dispose of the plug immediately, to avoid a possible shock hazard by
inadvertent.
Connection to the mains supply.

IMPORTANT : The wires in the mains lead are coloured in accordance

with the following code :

Blue

: Neutral

Brown : Live

Do not connect those leads to the earth terminal of a three-pin plug.

For the United Kingdom

REQUIREMENT BY NEDERLAND GAZETTE

Batteries are supplied with this product. When
they empty, you should not throw away. Instead,
hand them in as small chemical waste.

Advertising