Kodak i55 - Manual (Page 74)

70 A-61527 May 2006
Cleaning the imaging
area 1. Remove dust and debris from this area by using a Staticide wipe or
a small brush. Be careful not to scratch the glass when cleaning.
Use caution when cleaning the upper and lower white
background strips. Be careful not to catch the small black tabs
with the Staticide wipe. These tabs are fragile and can bend or
break.
IMPORTANT: Staticide wipes contain isopropanol which can cause
eye irritation and dry skin. Wash your hands with soap
and water after performing maintenance procedures.
Refer to MSDS for more information.
2. Wipe the imaging area again with an almost-dry Staticide wipe to
remove any streaks.
3. When finished, close the ADF cover.
Cleaning the platen glass To clean the smudges and fingerprints on the platen glass:
1. Open the flatbed cover.
2. Wipe the flatbed platen glass with a fresh Staticide wipe.
3. Wipe the flatbed platen glass with a dry Staticide wipe.