Kodak i55 - Manual (Page 8)

4 A-61527 May 2006
Environmental
information
• The Kodak i55 and i65 Scanners are designed to meet worldwide
environmental requirements.
• Guidelines are available for the disposal of consumable items that
are replaced during maintenance or service; follow local regulations
or contact Kodak locally for more information.
• The Kodak i55 and i65 Scanners contain lead in the circuit board
solder, glass lens and mercury in the lamps. Disposal of this material
may be regulated due to environmental considerations. For disposal
or recycling information, contact your local authorities or, in the USA,
visit the Electronics Industry Alliance website: www.eiae.org.
• The product packaging is recyclable.
• The Kodak i55 and i65 Scanners are Energy Star compliant and are
shipped from the factory with the default time set to 15 minutes.
EMC statements
United States This equipment has been tested and found to comply with the limits for
a Class B digital device pursuant to Part 15 of the FCC rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instruction manual, may cause harmful
interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
additional suggestions.
Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate
the equipment. Where shielded interface cables have been provided
with the product or specified additional components or accessories
elsewhere defined to be used with the installation of the product, they
must be used in order to ensure compliance with FCC regulation.