Kodak i55 - Manual (Page 20)

16 A-61527 May 2006
3. Plug the output power cord from the power supply into the power
port on the scanner.
4. Plug the input power cord into the wall outlet.
Set up the input and
output trays Detailed procedures and illustrations for installing and adjusting the
input and output trays can be found in Chapter 3, Using the Scanner.
Following is a brief outline of these procedures to get you started.
1. Lift the input tray to about a 45° angle.
2. Pull the input tray wire leg down.
3. Place the wire leg on the top of the clips on the flatbed cover and
press down to snap the wire leg into the clips.
4. Install the output tray by inserting the three tabs on the output tray
into the three slots on the automatic document feeder.
Unlocking the scanner The scanner has a shipping switch that locks the scanner’s flatbed
camera to avoid causing damage during transportation.
• Unlock the shipping switch before you power up the scanner.
• Lock the shipping switch before moving the scanner to a new
location. See the section entitled, “Locking the scanner” in Chapter 5
for procedures.
To unlock the scanner:
1. Place the scanner in an upright position on its front.
2. Unlock the scanner by moving the shipping switch (located on the
bottom of the scanner) down into the unlocked position.
3. Place the scanner back in its normal position.
Shipping
switch