Kodak i55 - Manual (Page 75)

A-61527 May 2006 71
Replacement
procedures
This section provides procedures for replacing the following parts.
• Feed module life varies depending upon paper types (chemically
treated papers), environment and cleanliness.
• Paper Feed roller life varies depending upon paper types
(chemically treated papers), environment and cleanliness.
• Input tray and flatbed cover only needs to be replaced if they get
damaged.
Replacing the feed
module Degradation of feeder performance, multiple feeds, stoppages, etc.
indicate a need to change the feed module. Failure to clean regularly,
and/or use of non-recommended cleaning solvents can shorten the
feed module life.
For additional feed modules, see the section entitled, “Supplies and
consumables” later in this chapter.
1. Open the ADF cover.
2. Squeeze the plastic clamps that hold the feed module in place and
lift it out of position.
3. Push the new feed module into position, aligning the new feed
module into the slots, until it snaps into place.
4. Close the ADF cover.