Kenwood TK-2200L - Manual (Page 21)

13
GETTING STARTED
1
2
1
1
3
Turn the Power switch/ Volume control
clockwise to switch the transceiver
power ON.
A beep sounds.
Rotate the Channel selector to select
your desired channel.
When you receive an appropriate signal,
you will hear audio from the speaker.
Adjust the volume as necessary.
To make a call, press and hold the PTT
switch, then speak into the microphone
to transmit. Release the PTT switch to
receive.
The LED lights red while transmitting.
For best sound quality, speak into the
microphone in your normal voice while
holding the microphone approximately
1.5 inches (3 to 4 cm) from your lips.
■
Channel Selector Scan Position (TK-3200L (K3) model only)
Scan is useful for monitoring signals on the transceiver channels. When
scanning, the transceiver checks for a signal on each channel and only
stops if a signal is present. For further details on how scan operates,
refer to “S
can
” on page 35.
1 S
15
13
11
9 7
5
3
Rotate the Channel selector and select the
“S” position to begin scanning.
The LED indicator flashes green and scanning
starts from the current channel and ascends
through the channel numbers.
During Scan, to stop scanning, rotate the
Channel selector to any position other than the
“S” position.