Kohler Freewill Barier Free Bath Whirlpools K-12106-H - Manual (Page 13)

13 115982-2- BA (-) Kohler Co., Kohler, WI
10. COMPLETE FINISH WALL
Install water-resistant wall material for either flush or
alcove installation as follows:
For flush installations: Install water-resistant wall
material to within 1/4” of the module edge. Install desired
trim around the unit to conceal the module edge. Also
install trim along the bottom apron edge.
Tape, mud, and finish the water-resistant wall material.
2x4 Studding
2” x 2” Brace
Acrylic Module
Water-Resistant
Wall Material
For alcove installations: Install water-resistant wall
material around the unit to conceal the module edge.
Tape, mud, and finish the water-resistant wall material.
2x4 Studding
2x2 Brace
Module
Water-Resistant
Wall Material
11. COMPLETE INSTALLATION
A. INSTALL WHIRLPOOL TRIM KIT
Refer to the installation instructions packed with the trim
kit when installing the jet or suction trim.
B. INSTALL FAUCET AND DRAIN TRIM
Install all finished faucet and drain trim according to
manufacturer’s instructions.
C. INSTALL EXTRA GRAB BARS
Any extra grab bars or towel bars should now be installed
through the module walls, and secured in place directly
to the bridging previously installed. Screws, bolts, and
backing should be selected to properly secure the grab
bars. Carefully seal around the grab bar fastener areas.
Follow the grab bar manufacturer’s instructions.
Grab bars can also be installed directly to the module,
providing the proper fastening device is selected to
securely attach the bar to the unit. Manufacturer’s
suggestions concerning grab bar installation must be
carefully followed.