Konica Minolta Polygon Editing Tool - Manual (Page 199)

197
Chapter
2
Build
Menu
9i
910
900
700
300
n Extracting a Line
Extract a line from the selected points as explained below.
Operating Procedure The following steps must be carried out in Build – Move – To X-Y-Z mode.
Parameters for [Select Line Attribute] Dialog Box
X-Axis Generates the X-axis based on the selected points.
Y-Axis Generates the Y-axis based on the selected points.
Z-Axis Generates the Z-axis based on the selected points.
1 Select the desired points.
M
emo
• Select the points using the Select and View menu com-
mands.
• After operation, please cancel the Select or View menu
command.
4 Click the [OK] button.
The line direction will be displayed, and the
[Question] dialog box will appear.
5 If you want to change the direction,
click the [No] button.
The line direction will be changed, and the
[Question] dialog box will reappear.
6 Click the [Yes] button.
The generated line will be displayed, and the
[Confirmation] dialog box will appear.
7 Click the [OK] button.
Proceed to the extraction procedure for the
next element (point or line).
• When you have completed extraction of all ele-
ments: Right-click the mouse to open the Ques-
tion dialog, and proceed to convert to the new
coordinate system.
2 Click the right mouse button.
The [Select Line Attribute] dialog box will ap-
pear.
3 Select the desired line attribute from
the pull-down menu.
Build – Move – To X-Y-Z