Kenwood TH78E - Manual (Page 9)

RECEIVER OPERATION
1 Getting Started
Connect the battery pack and the supplied antenna.
Press the POWER switch to turn the transceiver on.
One of the default frequencies should appear on the
display.
2 Tuning Control and Volume Control
This transceiver assigns two volume and tuning
control functions to the two controls.
Before proceeding to the next step, master these
functions. The default setting is as follows:
Functions as the Functions as the
volume control for
tuning control for
the UHF band. the UHF band.
dissappear
-after 2
seconds
If the display shows incomplete data, or you think the
displayed frequency is wrong, reset the micro-
processor Memory Initialization (see page 19)
10