KORG Electronic Keyboard - Manual (Page 759)

Master Effects (MFX1, 2) Routing
749
OSC1/EXi1 Send1=127 (100%) *064 (50%)=064 (50%)
OSC1/EXi1 Send2=064 (50%) *127 (100%)=064 (50%)
OSC2/EXi2 Send1=064 (50%) *064 (50%)=032 (25%)
OSC2/EXi2 Send2=127 (100%) *127 (100%)=127 (100%)
If IFX1–12 is selected for Bus Select, use the Send1 and
Send2 parameters for the post-IFX signals. If 1–8, or
1/2–7/8 is selected instead, these Send1 and 2 settings
are ignored and the Master Effect is not applied.
Send1 responds to CC#93, and Send2 responds to
CC#91. If Send1 (to MFX1) and Send2 (MFX2)” for
each timbre/track are effective, the parameter will
be controlled on the MIDI channels set for the
corresponding timbres and tracks. If the Send1 and
Send2 parameters for the post-IFX1–12 signals are
effective, they can be controlled on the MIDI
channels assigned to IFX1–12.
Note: You can use the control surface to control Send1
and 2. For details, see “8–1f: OSC MFX Send” on
page 125.
An example for Combination mode is given below. In
the upper figure (Fig. 2–2a), Bus Select is set so that
Timbre 1 is routed to IFX1, Timbre 2 to IFX2, Timbre 3
to IFX3, Timbre 4 to IFX4, Timbres 5 and 6 to IFX5, and
Timbres 7 and 16 to L/R. In this case, use Send1 and
Send2 for the post-IFX1 (001:St. Dyna Compressor)
signal to set the send level of the Timbre 1 routed to the
Master Effect. (In this example they are set to 032 and
127.) In the same way, use Send1 and Send2 for the
Fig. 2–1b
Fig. 2–1c