KORG TouchView Trinity ProX - Manual (Page 48)

26: Delay
44
26: Delay
This delay effect delays the input signal over time. You can change the character of the delay sound by
setting the feedback damping amount separately for the low range and high range.
a Delay Time [msec] 0.0…680.0msec Sets the delay time.
b
Feedback –100…+100 Sets the feedback amount.
Src None…Tempo Modulation source of the feedback amount
Amt –100…+100 Modulation amount of the feedback amount
c High Damp [%] 0…100% Damping amount in the high range ☞ P.44
d Low Damp [%] 0…100% Damping amount in the low range ☞ P.44
e
Input Level D-mod: Src None…Tempo Modulation source of the input level ☞ P.44
Amt –100…+100 Modulation amount of the input level
f
Wet/Dry Dry, 1:99…99:1, Wet Sets the balance between the effect and dry sounds.
Src None…Tempo Modulation source of effect balance
Amt –100…+100 Modulation amount of effect balance
c: High Damp [%]
d: Low Damp [%] These parameters set the damping amount for the high range and low range
respectively. Each time feedback is input, the tone of the delay sound becomes
darker, or lighter.
e: Input Level D-mod: Src:
e: Amt These parameters set dynamic modulation of the input level.
Delay
In
Feedback
Wet / Dry
Mono In - Mono Out
Input Level D-mod
High Damp Low Damp
Input Level
Louder
Max Zero
Higher
D -mod
Input Level
Max Zero
Higher
D -mod
x1.0
x0.5
Amt= +100
Amt= +50
Louder
x1.0
x0.5
Amt= –100
Amt= –50
Input Level D-mod