Kyocera FS-C8008DN User Manual

Page 149

Advertising
background image

4.2 Print Quality Problems

4-4

Black or white vertical streaks

Check the operator panel for toner.

If the Toner low (C/M/Y/K) message is dis-
played with color description, install a new toner kit
for the color. To replace the toner container, see

Chapter 5 Maintenance, section 5.1 Toner Con-
tainer Replacement on page 5-2

.

Clean the main charger.

Open the printer front cover. Pull the green cleaning
knob slowly in and out a few times. For full details,
see

Chapter 5 Maintenance, section 5.3.2 Cleaning

the Main Charger Unit on page 5-12

.

Have a service person check the fuser unit.

Faint or blurred printing

Clean the main charger.

Open the printer front cover. Pull the green cleaning
knob slowly in and out a few times. For full details,
see

Chapter 5 Maintenance, section 5.3.2 Cleaning

the Main Charger Unit on page 5-12

.

Check the primary transfer unit for jammed paper
remaining.

For removal of jammed paper, see

Paper Jam —

Paper Transfer Unit on page 4-17

.

Make sure the paper type setting is correct the paper
being used. See

Chapter 3 Using the Operator

Panel, section 3.10.4 Setting the Cassette Paper
Type on page 3-73

.

Conduct color calibration either by switching the
printer off then on or using the printer operator
panel (MENU). For full details, see

Chapter 3

Using the Operator Panel, section 3.13.12 Color
Calibration on page 3-100

.

Try adjusting the color control settings using the
printer driver.

Try switching the tone mode between Normal and
Fine using the operator panel (Menu>Print Qual-
ity
>Tone).

Check the operator panel. If the Toner low (C/
M/Y/K)

message is displayed with color descrip-

tion, install a new toner kit for the color. To replace
toner, see

Chapter 5 Maintenance, section 5.1

Toner Container Replacement on page 5-2

.

Moisture condensation may have been occurred on
the primary transfer unit. Open the printer front
cover, draw the paper transfer unit out, and draw the
primary transfer unit. Allow approximately 2 hours
until the condensation dries up.

Printed Results

Corrective Action

Table 4-2 (Continued)

Direction
of Paper
Feed

Advertising