Kyocera FS-C8008DN - Manual (Page 43)

2.4 Special Paper
2-12
Transparency
Transparencies for overhead projectors must withstand the heat of fusing during the printing
process. The recommended transparency product is as follows:
3M CG3700 (Letter, A4)
Transparencies must be placed on the MP (multi-purpose) tray with the long edge towards
the printer. To avoid problems, stack transparencies face up on the face-up tray.
Figure 2-10
When unloading transparencies (e.g., for clearing jams), hold them carefully by the edges to
avoid leaving fingerprints on them.
Adhesive-backed labels
Label paper must be fed manually.
For printing on labels, use extreme care so that the adhesive may not come in direct contact
with any part of the printer. Adhesives that stick to the drum or rollers will cause printer
damage.
Labels consist of three parts. Printing is done onto the top sheet (also called the face sheet).
The adhesive contains chemicals. The carrier sheet (also called the backing paper or liner)
bears the top sheet. This composition of labels can cause more problems than other print
forms during printing.
Figure 2-11
When using label paper, do not leave gaps between the arranged labels (i.e., top sheets).
Labels arranged with gaps in-between can easily be peeled off during printing, causing
serious jam problems.
MP Tray
Top sheet (white bond paper)
Adhesive
Carrier sheet