Kensington iP-30 - Manual (Page 23)

E-
Regular Operation
This section describes the use of direct operation using the projector and remote control buttons.
Please see the items on Page E-32 "Menu Operation Method" and Page E-35 "Menu Description" for information
about operation using the menu.
Select the Input
Operation with the Projector
Select the input using the INPUT buttons.
The input switches in the order OHP
→ PC → VID-
EO or OHP → VIDEO (D4) → VIDEO each time the
button is pressed.
Operation with the Remote Control
Select the input using the INPUT SELECT buttons.
When the projector’s power is turned on, one of the input selection icons ([OHP, PC or VIDEO] or [OHP, VIDEO (D4)
or VIDEO]) is displayed.
ON/STANDBY
LAMP/COVER
TEMP
FREEZE OFF FREEZE /CAPTURE PORTRAIT INPUT POWER
TRANSFER
OHP
This operation switches the (vertical/horizontal) orientation of the currently projected image.
The display of the switched screen is adjusted to match the width.
Operation with the Projector
Press the PORTRAIT button.
Operation with the Remote Control
Press the PORTRAIT button.
A B C
ON/STANDBY
LAMP/COVER
TEMP
FREEZE OFF FREEZE /CAPTURE PORTRAIT INPUT POWER
TRANSFER
PC VIDEO
OHP
VIDEO (D4)
VIDEO
(When the PC input is set to RGB)
(When the PC input is set to component)
* For instructions on selecting the PC input, see page E-35.
NOTE:
• The input mode at starting time will be the same as it was the last time the projector was switched off.
• When the icon is displayed, either the left or right key permits input switching.
Changing the Orientation of the Projection Image
Effective Only with OHP Input