Kenwood NEXEDGE NX-700H - Manual (Page 15)

9
BASIC OPERATIONS
S
wiTching
p
ower
on/oFF
Press and hold the switch for approximately  second to turn the transceiver
power ON. Press and hold the switch again to turn the transceiver OFF.
■
Transceiver Password
If the transceiver is password protected, “PASSWORD” will appear on the
display when the power is turned ON. To unlock the transceiver, enter the
correct password:
1 Select a character using the and keys.
• If you are using a microphone keypad, you can enter the password by direclty
pressing the DTMF keys instead.
2 Press the key to enter the selected character.
• This step is unnecessary when using a keypad.
3 Repeat steps  and 2 to enter the entire password.
• Press the key or microphone # key to delete an incorrectly entered character.
Press and hold the key or microphone # key to delete all characters.
4 Press the key or microphone key to confirm the entry.
• If you enter an incorrect password, an error tone sounds and the transceiver
remains locked.
• The password can contain a maximum of 6 digits.
A
djuSTing The
v
olume
Press the keys programmed with Volume Up/ Volume Down to adjust the
volume level.
S
elecTing A
Z
one And
c
hAnnel
/g
roup
id
Select the desired zone using the keys programmed as Zone Up/ Zone Down.
Each zone contains a group of channels.
Select the desired channel/group ID using the keys programmed as
CH/GID Up /
CH/GID Down. Each channel/group ID is programmed with settings for
transmitting and receiving.
Names can be programmed for zones and channels/group IDs. Each name can
contain up to 4 characters.
• You can toggle the display between the zone and channel/group ID names and number
by pressing the key programmed as Display Format, or by accessing the Display Format
function through the Menu {page 2}.