KORG MR-2000S - Manual (Page 9)

9
Basic operation
1. Power and usage
Plug the power cable into an AC outlet.
Connect the power cable to the AC connector on the back of the MR-2000S.
When you connect the power cable, the MR-2000S will enter the Off (Standby) status in approximately one
second, and the power LED will light-up red.
You must use only the included power cable. Using any other power cable may cause malfunctions.
2. Connecting your monitor equipment
Connect your monitor system to the output jacks. You can use either the XLR or RCA jacks.
Connect stereo headphones to the headphone jack. Use the phones knob to adjust the volume.
Connecting headphones will not cut the sound from the output jacks.
3. Turning the power on/off
The MR-2000S contains an internal hard drive, and should be considered a precision device comparable to
a computer.
You must observe the following procedure when turning the MR-2000S on or off.
Turning the power on
Press the power button.
The power LED will turn green, the opening screen will appear, and then
the home screen will appear.
Turning the power off
Hold down the power button for at least two seconds. The shutdown
screen will appear, the power will automatically turn off several seconds
later, and then the power LED will turn red.
If you disconnect the power cable before the MR-2000S turns off, you
may lose data or damage the internal circuitry.
Before you disconnect the power cable, make sure that the power LED is lit red and the screen has gone
blank (power off).
When you disconnect the power cable, the power will be completely off and the power LED will go
dark.