Kenwood R-K711 - Manual (Page 73)

73 English
Troubleshooting
Apparent faults or malfunctions may be easily resolved. Before calling for service, check the table
below for symptoms that match yours.
Symptoms Solution Ref. page
Amplifi er/Speakers
There is no sound. Check that the system is connected properly, as
described in “Connecting the System”.
Increase the volume.
Cancel the MUTE setting.
If there are headphones plugged into the main unit,
unplug them. z
z
z
z
10 - 13
20
20
13
The [STANDBY/TIMER]
indicator is fl ashing red
and there is no sound. One of the speaker cords is short-circuited. Unplug the
power cord and then reconnect the speaker cord.
There may be an internal problem. Turn off the power
to the main unit, unplug the power cord and request
repairs. z
z
—
There is no sound
from the headphones. Check that the headphone plug is inserted correctly.
Increase the volume.
Cancel the MUTE setting. z
z
z 13
20
20
There is no sound from
“D-IN”. Check that the system is connected properly, as
described in “Connecting the System”.
Check whether “PCM” is selected as the digital audio
output setting on the connected component. z
z
13
There is no sound from
one of the speakers. Check that the system is connected properly, as
described in “Connecting the System”.
Adjust the balance. z
z
10
60
There is a booming sound
when I select PHONO as
the input source. Insert the audio cord plugs securely into the [PHONO IN]
jacks.
Connect the signal earth wire to the [
M] terminal.
z
z
12
12
The clock display is
fl ashing. Set the time as described in “Setting the Time”. z 69
The timer does not
work. Set the time as described in “Setting the Time”.
Set a start time and end time for the program timer. z
z 69
63
I can’t get reception
from a radio station. Connect the antennas.
Select the broadcast band (AM or FM).
Tune the radio to the frequency of the desired station. z
z
z 10
36
36
There is interference
(noise). Install an outdoor antenna away from the road.
Turn off any electrical appliances that may be causing
interference.
Move the system away from the TV. z
z
z
—
I have used Auto Memory
and pressed the [P.CALL]
key, but I still can’t get
radio reception. Run Auto Memory again.
Manually preset stations with frequencies that you can
receive. z
z 38
39
Tuner
Symptoms Solution Ref. page