Kenwood XD-980MD - Manual (Page 17)

XD-980MD (En)
1 7
Preparation section
Basic
section
Application section
Knowledge sections
Let's put out some sound
Muting the sound temporarily
(Remote control unit only)
Listening through headphones
1Insert the headphone plug into the PHONES jack.
÷ The sounds from all speakers are cut off.
÷ Press again to resume the original volume.
÷
This is also cancelled when the volume is changed.
2Adjust the volume.
Remote control unit
Bass compensation
(N.B.CIRCUIT : Natural Bass circuit)
(Remote control unit only)
Blinks
Lights
÷ Not operating when the input selection is set to AUX. At the time of
TUNER, this operates only when the volume is set to zero.
When CD has been selected.
AUTO POWER SAVE function
When the unit is ON and neither recording nor playback is ex-
ecuted for 30 minutes or more, the unit is switched off auto-
matically by this function. This function can be made active or
not active by the following operation.
Each press switches the modes as follows.
1 “ON” .... Auto power save is used.
2 “OFF” ... Auto power save is not used.
Volume display
Bass and treble compensation
(EX. BASS)
The factory default is ON.
Bass and treble range are compensated.
C D ) 1 1 5 )
EX . BASS
:
1
MUTE
N.B.
Remote control unit
PHONES
EX . BASS
N B 1
1
N.B.
Each press switches the modes as follows.
1 N.B.1 ............... The bass range is compensated ac-
cording to the volume (effective at
low volume).
2 N.B.2 ............... Bass range compensation indepen-
dent of the volume.
3 N.B.OFF .......... N.B. cancellation.
C D ) 1 1 5 )
EX . BASS
:
1
÷ Switching between ON and OFF each time the key is pressed.
EX.BASS
D
O W
N
UP MULTI CONTROL
/VOLUME
E R s A V E O N .
V O L 2 )
EX . BASS
1 2 3
RUNNING
INDICATOR
EQ.
CLASSIC
MANUAL
POP ROCK
VOL.
6
7
8
9
10
11
1
2
3 4 5
C D ) 1 ) ) )
EX . BASS
:
1 2 3
RUNNING
INDICATOR
EQ.
CLASSIC
MANUAL
POP ROCK
VOL.
6
7
8
9
10
11
1
2
3 4 5
AUTO POWER
SAVE
STANDBY mode of ON/STANDBY key
When the power cord of this system is plugged into an AC out-
let, the display lights up regardless of the ON/OFF setting of the
ON/STANDBY key. This indicates that a small amount of cur-
rent is being supplied to the unit to back up the memory con-
tents. This mode is referred to as the standby mode. While the
display is lit, the system can be switched ON/OFF from the re-
mote control unit.