Kenwood XD-980MD - Manual (Page 79)

XD-980MD (En)
7 9
Preparation section
Basic
section
Application section
Knowledge sections
In case of difficulty
Remedy Cause Symptom
CD player section
÷ Place the disc properly, with the label side
facing upward.
÷ Place the disc properly.
÷
Clean the disc referring to “Disc handling
precautions”.
÷ Try another disc.
÷
Refer to “Beware of condensation” and
remove the condensation by evaporation.
÷
Place a disc in the CD player.
÷ Press the 6 key.
÷
Clean the disc referring to “Disc handling
precautions”.
÷
Try another disc.
÷ Clean the disc referring to “Disc handling
precautions”.
÷
Try another disc.
÷
Install the unit in a place not subject to
vibrations.
A CD is placed in the player but it cannot
be played.
Sound is not produced.
Sound skips.
÷ The disc is placed upside down.
÷ The disc position is displaced.
÷
The disc is extremely dirty.
÷ The disc is scratched.
÷
Dew is condensed on the optics lens.
÷
The disc has not been placed.
÷ The player is not put to the play mode.
÷
The disc is extremely dirty.
÷
The disc is scratched.
÷ The disc is dirty.
÷
The disc is scratched.
÷
The player is subject to vibration.
5
d
5
5
5
CD player section (in regard to message display)
Displayed Message Meaning Action
Err** (** indicates a number) ÷ This indicates some trouble. The number
differs according to the trouble contents. ÷ Return to normal condition is made by
switching the unit off and then on again.
Remote control unit
Symptom Cause Remedy
Remote control operation is not possible. ÷ Batteries are exhausted.
÷
The remote control is too far away from the
system, the controlling angle is deviated or
there is an obstacle in between.
÷
There is no CD or MD set in the component
to be played.
÷ Replace with new batteries.
÷
Operate the unit inside the remote control-
lable range.
÷
Set a CD or MD in the component to be
played.
%
%