Kenwood XD-980MD - Manual (Page 70)

XD-980MD (En)
7 0
Preparation section
Basic section
Application section
Knowledge sections
Adjust the clock before setting the timer.
Timer operation
Select a program No.
Set the ON/STANDBY key to STANDBY position.
Adjust the listening volume.
Make preparations for the play (recording).
÷
For recording of broadcasts, the minimum volume is set
automatically when the unit is switched on by the timer.
Make prepa-
rations for re-
cording.
Cassette deck
(option)
MD
§
Make timer set-
ting of the com-
ponent connected
to the AUX or
VIDEO jacks. Set a tape into.
Cassette deck
(option) Insert a disc.
(Program playback is
not possible.) The station
should be pre-
set prior to the
above.
∞
Select the disc (1, 2, 3)
to be played.
÷
Timer reservation is possible for the two types PROG.1 and PROG. 2
at the same time.
÷
Please make reservations with an interval of at least one minute, so that
the operation times of PROG. 1 and PROG. 2 do not overlap.
Timer programming
Two 24-hour timer systems (PROG.1, PROG.2) (which can be used every day) are available.
In each of PROG.1 and PROG.2, the timer data including the operating period and played contents can be set and selected to
be activated or not as required.
For tape timer operation, please read the operation manual of the cassette deck (option) carefully.
1
2
3
4
÷
The selected program No. lights.
÷
If a program No. under which a timer program has already been
reserved, it is replaced by the new timer program.
1
2
Each press of the key switches the program numbers as follows.
1 PROG.1..... Program 1
2 PROG.2..... Program 2
3 Normal operation
The MD operates on the basis of the information read
from the disk into memory.
Before timer setting with the MD, leave the power ON
for 10 min. or more to make the memory backup func-
tion effective.
k
Note Note
Press during display of the
program contents.
Load a disc.
To listen to CD
Playing the auxil-
iary input source
To listen to MD To listen to tape For recording To listen to radio
Connect the related equipment under reference to “System connection”. 6
ENTER
EX.BASS
ON/STANDBY
PROG.
A M 1 ) ) )
1
:
D
O W
N
UP MULTI CONTROL
/VOLUME