Kompernass PKGS1450 - Manual (Page 4)

Introduction
Chop and mitre saw
PKGS 1450 LASER
Chop, mitre and combination cuts
L Introduction
L Your safety
Please make sure you familiarise yourself
fully with the way the device works before
you use it for the first time and that you
understand how to handle electrical power tools
correctly. Further details can be found in the operating
instructions.
In addition, you must also observe the general safety
advice contained in the accompanying booklet. Keep
these instructions in a safe place. If you pass the
device on to anyone else, please ensure that you
also pass on all the documentation.
L
Proper use
For sawing solid wood, chipboard and plastic. With
the laminate cutting attachment
{ in place the
machine is suitable for laminate and material up to
20 cm wide. Please note that the blade pre-installed
in the saw as supplied is intended for use with wood
only. Any other use or modification to the device shall
be considered as improper use and could give rise
to considerable dangers. The manufacturer will not
accept liability for loss or damage arising from
improper use. Not suitable for commercial use.
L
Features and equipment
Q Saw motor unit
W Switch handle
E Safety lever
R Sliding roller (with automatic blade guard)
T Saw table
Y Lateral support stirrup
U Lateral support stirrup clamp screws
I Mitre angle stop
O Saw table setting knob
P Mitre angle scale
{ Laminate cutting attachment
} Mounting holes
q Stop plate
w Saw motor unit setting knob
e Rear support stirrup
r Sawdust removal connector
t Laser beam emission opening
y Screw (for attaching the saw blade)
u Outside flange
i Laser On / Off switch (Fig. C)
o Transport lock (Fig. A)
p Saw blade depth setting screw (Fig. A)
[ Scale on the saw motor unit (Fig. A)
] Mitre angle / 0° setting screw (Fig. A)
A Saw motor unit mounting screws (Fig. A)
S Mitre angle / 45° setting screw (Fig. B)
D On / Off switch (Fig. C)
F Rotation speed selector wheel (Fig. C)
G Table insert (Fig. B)
H Laser setting screw (Fig. B)
L
Included items
1 Chop and mitre saw
1 Laminate cutting attachment
{
2 Lateral support stirrups Y
1 Sawdust collection bag (a)
2 Screw clamps (b)
2 Carbon brushes (c) (see section on maintenance)
2 Allen keys (d), sizes 5 mm and 6 mm
1 Locking spanner (e)
1 Socket spanner (13 mm) (f)
1 Universal saw blade: 250 x 30 x 2.35 mm,
80 HM - teeth (3.2 mm)
1 Saw blade for wood
(supplied installed): 250 x 30 x 1.8 mm,
36 HM - teeth (3.0 mm)
1 Operating instructions
1 Booklet “Guarantee and service”
1 Booklet “Containing general safety advice”
6 GB/IE