Kompernass PKGS1450 - Manual (Page 9)

Empty the sawdust collection bag regularly.
Open the zip fastener to empty the bag.
L Unlocking and switching
the machine on and off
j Unlock the machine by pushing the safety lever E
to the right.
Switching on:
j Press the On / Off switch D and keep it pressed.
Note: There is a delay in the machine starting up
.
Switching off:
j Release the On / Off switch D .
j Secure the machine again by moving the saw
motor unit Q downwards and pressing the
transport lock o to the left.
L
Switching the laser on and off
and adjusting it
Avoiding harm from the laser beam!
The laser beam indicates the cutting line of the saw
blade. Align the marks on your workpiece with the
track of the laser beam.
Switching on:
j Press the laser On / Off switch i into position I.
Switching off:
j Press the laser On / Off switch i into position 0.
Adjusting the laser beam:
j Turn the laser setting screw H to adjust the
laser beam.
L
Setting the speed
You can pre-select the speed you require using
the rotation speed selector wheel
F .
Increasing speed:
j Turn the rotation speed selector wheel F
towards marking 6 or in the + direction
(6= highest speed).
Reducing speed:
j Turn the rotation speed selector wheel F
towards marking 1 or in the – direction
(1= lowest speed).
L Transporting the machine
j Before you transport the machine always lock
the transport restraint by engaging the transport
lock
o with the saw motor unit Q lowered.
When you carry the machine always hold it by
the base.
L
Attaching the laminate cutting
attachment and cutting laminate
The patented laminate cutting attachment { allows
you to cut laminate to your required lengths quickly
and cleanly. Note that the laminate cutting attach-
ment
{ is designed exclusively for laminate and
a material width of up to 20 cm. It is suitable for
almost all types of commercially available laminate
floor coverings.
j Loosen the two stop plate q setting screws
using the supplied 6 mm Allen key (d) and re-
move the stop plate.
j Insert in its place the laminate cutting attach-
ment { and screw it to the saw table T .
j Place the laminate flush against the edge of
the stop of the laminate cutting attachment { .
L
Mitre cuts – turning the saw table
j Loosen the setting knob for saw table O . Press
the mitre angle stop I and turn the saw table T
using the saw table setting knob O to the left or
right into the desired position. Release the mitre
angle stop
I again and tighten the saw table
setting knob O .
Operation
11 GB/IE