Kompernass PKGS1450 - Manual (Page 5)

Introduction / Safety
L Replaceable parts
You can replace the following parts yourself.
When you do this always observe the relevant ope-
rating instructions and safety advice.
- Sawdust collection bag (a)
- Laminate cutting attachment {
- Stop plate q
- Saw blade
Have any other maintenance and repair tasks car-
ried out by our service centre or an accredited elec-
trical equipment repair centre.
L Technical information
Nominal output: 1450 W
Nominal voltage: 230 V ~ 50 Hz
Nominal speed: n
0
1800 - 4500 min -1
Circumferential speed: 24 m / s – 55 m / s
Weight:
14.5 kg
Protection class: II / &
Sound pressure level: Lp = 95.5 dB (A)
Sound power level:
Lw = 108.5 dB (A)
Vibration: 2.5 m / s 2
Saw blade for wood
(supplied installed):
250 x 30 x 1.8 mm,
36 HM - teeth (3.0 mm)
Universal saw blade: 250 x 30 x 2.35 mm,
80 HM - teeth (3.2 mm)
Cutting capacity:
Cutting width:
max. 140 mm (without
laminate cutting attachment)
max. 200 mm (with laminate
cutting attachment)
Cutting depth: max. 65 mm
L Safety
Safety advice relating
specifically to this saw
J Ensure that the device is always used in accord-
ance with the advice in these operating instruc-
tions and only by persons over 18 years of age.
J Keep children away from the device.
Store the device indoors in an enclosed,
dry place where it cannot be reached
by children.
J In addition, you must also read the advice in the
accompanying booklet containing safety advice
before using the device for the first time.
J Check that all moving parts on the tool are working
properly, can move freely and are not damaged.
All parts must be correctly attached and fulfil all
the requirements necessary to allow the electrical
tool to operate properly.
J Carry out the following before each use:
- check the saw for damaged parts or safety
equipment and if necessary have them
replaced by an electrician.
- check the saw blade for quality / condition,
sharpness, cleanliness and free movement.
- check that the saw blade is properly attached
and does not wobble. Attach the saw blade
by placing the locking spanner (e) on the ou-
ter flange
u and tightening the screw (for
attaching the saw blade) y counter-clock-
wise.
To avoid danger to life
from electric shock:
J Do not operate the device if the
mains lead or mains plug is damaged.
Caution! A damaged mains lead
presents a serious danger to life from electric
shock. The service centre for your country is
shown in the guarantee documentation.
J Have repairs carried out only by an electrician or
the relevant service centre.
7 GB/IE