Kohler K-1111 - Manual (Page 7)

Filling and Operating Your Whirlpool
NOTE: Please read these steps carefully before operating your whirlpool.
NOTE: The water temperature in the whirlpool should not exceed 104° F (40° C). The heater will
automatically turn off as the water temperature approaches 104° F (40° C) and will remain off until the
water cools.
Turn the jet trim fully counterclockwise. Position the jet nozzles so they face down toward the basin.
Close the drain and fill the bath to a level at least 2
″
(5.1 cm) above the top of the highest jet.
Place your hand in the bath to test the water temperature for comfort and safety, then carefully
enter the bath.
Press the
″
Power On/Off
″
button on the keypad to activate the whirlpool. The heater will turn on
and the whirlpool will start at a medium water flow volume. Three small lights near the whirlpool
floor will illuminate until the keypad goes into sleep mode.
Press the up/down arrow buttons to increase or decrease the water flow volume. The indicator bar
in the center of the keypad displays the current water flow volume.
Rotate the jet trim clockwise to reduce the air/water flow or counterclockwise to increase the
air/water flow.
Position the Flexjet nozzles to direct the water flow to maximize your hydro-massage experience.
To turn the heater off, rotate the outer ring of the keypad until the heater mode is flashing and press
the
″
OK
″
button. Press
″
OK
″
again to turn the heater back on.
Press the
″
Power On/Off
″
button to turn the whirlpool off. The three small lights near the whirlpool
floor will remain illuminated until the keypad goes into sleep mode.
Repeat the steps above to verify the second keypad is operating properly, less the chromatherapy
functions.
NOTE: The whirlpool will automatically shut off approximately 20 minutes after continuous operation.
You may reactivate the whirlpool by pressing the
″
Power On/Off
″
button.
Turn the Flexjet
trim clockwise to
decrease the flow.
Turn the Flexjet trim
counterclockwise to
increase the flow.
Position the jet nozzles
to direct the water flow
as desired.
Fill with water 2" (5.1 cm)
above the highest jet.
Kohler Co. 7 1042951-5-B