Kohler K-1111 - Manual (Page 9)

Programming the Remote Control (cont.)
Turn the whirlpool power on.
Turn off all modes of operation. Wait approximately one minute until the keypad darkens
completely.
On the user keypad, press the up arrow, down arrow and the
″
OK
″
button simultaneously. The
bottom LED on the keypads indicator bar will begin flashing.
While the LED is flashing, press the
″
OK
″
button on the keypad. A light sequence will illuminate up
and down the indicator bar.
While the indicator bar light sequence is active, press any button on the remote control. The
program will download and the user keypad will darken. The user keypad will now respond only
to this remote control.
Cleaning Your Acrylic Whirlpool
Do not use abrasive cleansers or solvents on acrylic surfaces.
Wipe out the product with a soft cloth after each use.
Avoid detergents, disinfectants, or cleaning products in aerosol cans.
If the surface gets excessively dirty you can use a general purpose cleaner such as: Formula 409
®
All
Purpose Cleaner, Gel Gloss
®
(Bath and Shower only), Scrub Free
®
Mildew Stain Remover, Mr.
Clean
®
Lemon Fresh, Cinch
®
, Glass Plus
®
, or Fantastik
®
All Purpose.
NOTE: To restore dull or scratched units: Apply white automotive polishing compound with a clean rag.
Rub scratches and dull areas vigorously. Wipe off residue. Follow with a coat of white automotive paste
wax. Do not wax areas where you walk or stand.
Cleaning Your Keypad and Remote Control
Use a soft cloth to wipe the keypad and remote control after each use. If the surface becomes dirty,
use a non-abrasive soap and warm water to clean.
Cleaning Your Removable Pillows
Clean your pillows twice a month or more, depending upon usage. Use mild soap and water on a
clean, soft cloth for routine cleaning. To clean stubborn stains, remove the pillows from the
whirlpool and use a high-quality cleaner recommended for vinyl. Periodically, use a vinyl treatment
product to rejuvenate the appearance of your pillows.
Flushing Your Whirlpool System
Flush your whirlpool system twice a month or more, depending upon usage. Use the following sequence:
Turn the jet trim rings fully clockwise to remove air induction.
Fill the whirlpool with warm water above the backjet level probes or leave water in the whirlpool
after using.
Add 2 tablespoons (30 ml) of a low-foaming dishwasher detergent and 20 ounces (590 ml) of
household bleach (5% - 6% sodium hypochlorite) to the water.
Run the whirlpool for 5 to 10 minutes. Turn off the whirlpool and drain.
If desired, rinse the bath surfaces with water.
Rinse the surfaces of the jets, faucet, handrails, drain, etc. and wipe them dry with a soft cloth.
Kohler Co. 9 1042951-5-B