KVH Industries TracVision 4 - Manual (Page 20)

6. Remove and save the three screws securing the
radome to the baseplate. Carefully lift the radome
straight up until clear of the antenna assembly and
set it aside in a safe place. If you bring the radome
topside, be sure to secure it with a lanyard so that
it does not fall overboard.
7. Remove the foam shipping restraint from the
antenna unit.
8. Using a 10 mm wrench, remove the two azimuth
shipping restraint bolts, washers, and spacers from
the antenna unit, as shown in Figure 2-5.
9. Place the foam seal in position on the mounting
surface with the hole centered over the cable
access cutout. Do not remove the paper backing at
this time. Align the seal with the vessel’s centerline
and the narrow end pointing toward the bow (see
Figure 2-6). Scribe a line all around the seal.
54-0150 16
TracVision 4 Technical Manual
Bow RF1
RF2
Data
Power
Foam Seal
Washer
Spacer
Bolt
Figure 2-6
Baseplate/Foam Seal Orientation
(Bottom View)
Figure 2-5
Azimuth Shipping
Restraint Removal
The shipping restraints must be
removed before power is applied.
Save the restraints for reuse and be
sure to install them whenever the
antenna unit is moved from place to
place. See Section 4.9, “Preparing
for Shipment” on page 66
for
instructions on preparing for
shipment.