KVH Industries TracVision 4 - Manual (Page 74)

Startup Data Sequences
54-0150 81
Appendix E
Startup Data Sequences
The data on the following pages presents a sample startup
data sequence registered by the TracVision 4 when receiving
signals from DIRECTV, the DISH Network, or ExpressVu. This
sequence may vary based on the software version loaded onto
the TracVision 4 system. This data can be recorded using the
maintenance port and a PC.
?PGM
TracVision G4 Controller Rev X - Version X.XX - Serial number XXXXXXXX
NMB Motors
RF: ZAP
*** Initializing RF Controller ***
RF: S,A,H,U,V
RF: SATINSTALL,55,C,57,C
RF: S,A,H,U,V
RF: L,A --------------------------------------Identifies Satellite A or B as currently
RF: SATCONFIG loaded for acquisition
RF: F,A,12368,20000,67,0X0000,V,U,2----------Satellite configuration data, Satellite A
RF: F,A,12368,20000,67,0X0000,V,U,2
RF: F,A,12238,20000,67,0X0000,H,U,2
RF: F,A,12238,20000,67,0X0000,H,U,2
RF: F,B,12374,20000,34,0X1004,V,U,3----------Satellite configuration data, Satellite B
RF: F,B,12374,20000,34,0X1004,V,U,3
RF: F,B,12381,20000,34,0X1004,H,U,3
RF: F,B,12381,20000,34,0X1004,H,U,3
RF: RF PCB Version 8.1 ----------------------Current RF software revision
RF: I,0,51496,00000,00516,0
RF COMM: PASS--------------------------------PASS is expected
Limit Switch Test
Limit Switch Status: PASS--------------------PASS is expected
*** Initializing Ext Sensor ***
RF: S,A,V,U,V
RF: ?
˛=h,0˛S˛=h,1RF: S,A,H,U,V
RF: S,A,V,U,V
ES Status Timeout
˛=h,0˛S˛=h,1ES Status Timeout
˛=h,0˛S˛=h,1RF: S,A,V,U,V
ES Status Timeout
Running Sensorless. No Ext Sensor Detected---Configuring for sensorless operation
*** Initializing Antenna ***
*** NO GPS-Default Used *** -----------------Accessing default location based on sat install
GPS: UTC: 083000.00, Lat: 4131.00N, Long: 7115.00W
GPS: DSS_119 AZ = 238.9, EL = 22.1-----------Default satellite position based on sat install