Kambrook Stick Mix KSB7 - Manual (Page 9)

8
Operating Your Kambrook Essentials
Stick Mix
continued
To Remove The Blending
Shaft
First switch off the power at the power
outlet and then unplug. Unscrew
the shaft from the motor unit by
turning the shaft in a clockwise
direction (Fig 1).
Fig. 1
To Attach The Blending Shaft
Align the mark on shaft with the
mark on the motor body and screw
the shaft into the motor unit by turning
the shaft in an anti-clockwise direction
(Fig 2).
Fig. 2
Make sure the mark on the shaft is
aligned with the mark on the motor
body and that a ‘click’ is felt.
Ensure shaft is dry with no water left
inside before re-attaching.
Using The Stick Mix
Place foodstuffs to be processed into
the Blending Jug or a sufficiently large
mixing bowl to avoid splashing.
Insert the plug into a 230V or 240V
power outlet and then turn the power
on at the power outlet.
Insert the Blending Shaft deeply
into the Blending Jug and press the
required speed control switch to the
low speed to turn the blender on.
High speed can be selected during
the processing task.
To efficiently process the foodstuff use
a gentle raising and lowering motion
(Fig 3).
Fig. 3
Switch off the unit and then lift the
stick mix out of the Blending Jug. To
avoid splashing allow the blades to
stop rotating before lifting the unit out
of the container.
The Essentials Stick Mix motor will only
stay on while the speed control switch
is depressed – this is a safety feature.
While blending always hold the
container with the other hand.
WARNING: Never blend
hot ingredients!