Kohler Coralais rite-temp bath and shower faucet 114522-2-CE - Manual (Page 2)

114552Ć2Ć CE Kohler Co., Kohler, WI
2
IMPORTANT INSTRUCTIONS
READ AND SAVE FOR THE CONSUMER
WARNING: Risk of scalding or other severe injury.
S Before completing installation, the installer must set the maximum
water temperature setting of this valve to minimize the risks
associated with scalding hazards according to ASTM F 444.
S Do not install a shutĆoff device on either outlet of this valve. The
installation of any such device may create a crossĆflow condition at
the valve and affect the water temperature.
S Factors that change the temperature of the water supplied to the
valve, such as seasonal water temperature changes, and water heater
replacement or servicing, will change the maximum water
temperature supplied by the valve and may create a scalding hazard.
The pressureĆbalanced valve will not compensate for changes in the
water supply temperature; adjust the maximum water temperature
setting of this pressureĆbalanced valve when such changes occur.
S PressureĆbalanced valves may not provide protection against scalding
if there is a failure of other temperatureĆlimiting devices elsewhere in
the plumbing system.
The installer is responsible for installing the valve and adjusting
the maximum water temperature of this pressureĆbalanced
valve according to instructions.
This valve meets or exceeds ANSI A112.18.1M and ASSE 1016.
If you do not understand any of the installation or temperature
adjustment instructions in this document, in the United States please
contact our Customer Service Department at 1-800-4-KOHLER . Outside
the U.S. please contact your distributor.
IMPORTANT: Please fill in the blanks below and on the valve label.
Then insert these instructions into the plastic bag included with the
valve package, and attach the plastic bag to the valve handle for the
owner's reference.
This device has been preset by ______________________
of _______________________ to ensure a safe maximum
temperature. Any change in the setting may raise the
discharge temperature above the limit considered
safe, and lead to scalds. Date: _____________