Kawasaki 1600 - Manual (Page 31)

PREPARATION 29
Viewed from Right
A. Positive Terminal (+)
B. Battery
C. Positive Cable (+)
D. ECU Relay
E. Negative Cable (–)
Viewed from Top
A. Negative Cable (–)
B. Run the Positive Cable (+) through
the Guide in the Battery Case.
C. Positive Cable (+)
D. Battery
E. 4 P Connector (Diagnosis)
F. 6 P Connector (Rear Harness)
G. Plastic Clamp
H. 15 A Fuse Holder
I. ECU Connector
J. 3 Connectors (1 P, 2 P, 3 P)
Rider’s Seat Installation
•
Insert the projection at the front of the rider’s
seat into the receptacle on the frame.
A. Projection
B. Receptacle
•
Install the bolt (D = 6, L = 14) and tighten it.
A. Rider’s Seat
B. Bolt (D = 6, L = 14)
•
Insert the projection at the front of the passen-
ger’s seat into the receptacle on the frame.
A. Receptacle
B. Projection
•
Install the bolt (D = 6, L = 14) and tighten it.