Konica Minolta Dimage Scan Elite F-2900 - Manual (Page 11)

9
CONNECTING THE HARDWARE
2. Connect one end of the SCSI cable to either SCSI
port on the back of the scanner
• Either SCSI port can be used for other configurations, there is no
dedicated in or out port.
1. Place the scanner on a level surface.
3. Connect the other end of the SCSI cable to the
SCSI port on the computer or the last device in
the SCSI chain.
Continued on the following page.
Connecting the SCSI Cable
This scanner has been packaged with the SCSI cable SC-11 (DB25-to-SCSI-1). See your dealer if
you require a different SCSI cable.
• To meet FCC regulations, the SCSI cables used with this scanner must be equipped with ferrite cores.
BEFORE YOU BEGIN…
TURN THE COMPUTER AND ALL CONNECTED
DEVICES OFF.