Konica Minolta bizhub 750 - Manual (Page 152)

Basic Copy Operations 3
bizhub 750/600 3-53
Ba
sic Copy Op
er
ations
Chapter 3
3.11 Selecting Finishing Settings
Various settings are available for sorting and finishing copies when they are
fed into the copy exit tray.
The Staple settings are available only if optional finisher FS-504 or FS-602 is
installed.
The Punch settings are available only if Punch kit PK-505 or if Z-folding unit
ZU-602 is installed on optional finisher FS-504 or FS-602.
2
Note
As the default setting, “Group” is selected.
!
Detail
If no finisher is installed and the following conditions are met, printed
copies can be fed out and sorted in an alternating crisscross pattern.
8-1/2 × 11 or 5-1/2 × 8-1/2 size paper is used.
Paper of the same size and type is loaded with the
w orientation in one
paper tray and with the
v orientation in another tray.
The “Auto Paper Select” setting is selected.
The “Auto Paper Select” setting is not selected when the “Mixed Original”
setting is selected.
If the orientation of the positioned original is different from the orientation
of the paper in the paper tray, specify the position of the binding margin
of the original if hole punching or stapling are to be performed.
For details on specifying the position of the binding margin for the origi-
nal, refer to “Selecting the Position of the Binding Margin (Margin Set-
tings)” on page 3-22.
The following Finishing Settings are available.