Kathrein UFD 580 - Manual (Page 45)

Hard Disk Recorder
45
One-Touch Recording (OTR)
With your twin-DVR Sat receiver you can immediately record the
current programme to the hard disk at the press of a button. All you
need to do is press the red

button. During recording, the red
standby LED on the front panel of the receiver flashes, and “ R ” (or 2 x
“ R ” if two recordings are being made) flashes in the top left-hand
corner of the screen for a few seconds.
Note: If you want to start recording within the first five minutes of the
programme you will need to press the red

button again and check
that the end (stop) time is correct. If required, you can enter the stop
time in half-hour increments using the

buttons or directly using
the number pad. Press

to save the change.
Recording is automatically stopped after switching EPG or after two
hours at the latest.
You can still select all other programmes.
If you press the

button, you will see the recording status and can
stop the recording process (see below).
Using the screenshot above, you can also check the recording status
without having to interrupt the recording. The stop time is indicated at
the right of the top bar. Press

to return to the full screen without
stopping recording.
Press

to view the hard disk contents.
Note: If you press the

button at this stage of recording, a second - time-
shifted - recording is started! You can stop that recording by pressing

and

or by pressing

.
You can stop recording by pressing

and

. You can then delete
the programmed recording by pressing

and

.
You can record an
encrypted programme
even if no CAM or
Smartcard is inserted!