Kathrein UFD 580 - Manual (Page 69)

Setting System Parameters
69
The summer time should be corrected as necessary in order for the
timers to turn on and off at correct times.
You can correct the time yourself in 30 minute increments using the

buttons. To do this, move the cursor bar to the “Local time” item
using the

button. Press

twice to end your input. The receiver
saves the new setting.
When you subsequently switch the receiver off, do so from the remote
control - not at the mains switch, otherwise the settings will be lost.
TV Type
Here, you can use the

buttons to specify whether your TV set
is a
• PAL,
• multi-standard or
• NTSC
set.
Press

twice to confirm.
Aspect Ratio
Here, you can use the

buttons to select the type of picture
format for which your TV set is designed. Either
• 4:3 format or
• 16:9 format or
• Auto
Press

twice to confirm.
Screen
Here, you can use the

buttons to select the type of screen
display.
• Conventional (P/S) = standard representation for 4:3 sets or
• Letterbox display – This setting enforces the widescreen format
for a 16:9 set.
Press

twice to confirm.
A/V Mode
Here, you can use the

buttons to select the type of video signal
at the Scart socket. Select the signal that your TV set can process.
Refer to the operating instructions for your television set!
• Composite colour – composite baseband signal
• RGB – Red/Green/Blue signal or
• Y/C – S-VHS signal (luminance/chrominance)
Press

twice to confirm your selection.