KVH Industries TracVision 6 - Manual (Page 63)

8. Route the new limit switch wires through the
cover and cable clamp to the main PCB’s Molex
connector. After noting the position of the old
black and white wires, remove the old wires from
the Molex connector. Attach the new wires in their
places.
9. Reinstall the PCB cover.
10. Before re-installing the azimuth limit switch to the
antenna assembly, orient the switch’s plastic cam
as shown in Figure 4-8. With the cam in the proper
position, reinstall the switch to the antenna
assembly using the three #6-32 retaining screws
and flat washers. Ensure the cam finger engages
the stop pin in the mounting cavity.
11. Apply hot melt or RTV at the limit switch cover’s
wire access hole to protect the wires from chafing
(see Figure 4-7).
54-0166 62
TracVision 6 Technical Manual
Plastic Cam
Black and White Wires
to Main PCB Molex Connector
Figure 4-8
Azimuth Limit Switch Orientation